Z Series E85 Z4 3.0i (N52) ROADST
32 21 231
Replacing (removing and installing) left or
right tie rod
Important!
The steering gear must be replaced if the polished surface of
the rack is damaged (e.g. by corrosion)!
Necessary preliminary tasks:
•
Remove tie rod end from steering knuckle
•
Remove gaiter from steering gear and slide back
Important!
To avoid damage to rack and to suspension mounting, move
rack in as far as possible.
Screw tie rod off rack of steering gear (34 WAF).
Installation:
Clean rack.
Check surface of rack for damage (e.g. corrosion).
Grease rack (refer to BMW Service Operating Fluids).
Tightening torque 32 21 2AZ
.
On replacement, assemble new part with gaiter:
•
Determine measurement (A) on old part to simplify following
adjustment of front axle
•
Slacken clamping nut (2)
•
Screw off tie rod end; if necessary, grip tie rod with open-end
wrench
•
Remove clamping ring (1) and screw off clamping nut (2)
•
Slide gaiter (4) and ear clamp and band clamp (3) onto tie
rod
RA Replacing (removing and installing) left or right tie rod
BMW AG - TIS
15.02.2013 19:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -