Z Series E85 Z4 3.0i (N52) ROADST
00 ... ...
Raising vehicle with trolley jack
Important!
Observe the following trolley-jack-related instructions:
1.
Use only BMW-distributed/approved trolley jacks which
have rubber plate contact points.
2.
Trolley jacks must be regularly serviced and always
checked for functional reliability before they are used!
3.
Check the rubber plate on the trolley jack prior to each
use, replacing if necessary.
Warning!
The vehicle may be raised with a trolley jack only at the
following jacking points!
1
Car jacking point
2
Side car jacking points
3
Rear differential (after removal of heat shield)
Risk of damage: It is not permitted to raise the vehicle at the
rear differential cover!
4
Bolting point for rear axle tension struts
Heat shield:
Important!
Risk of damage
Because of the fitted heat shield, it is not permitted to raise
the car at the rear differential.
Remove expanding rivet (1).
Release screws and remove heat shield (2).
RA Raising vehicle with trolley jack
BMW AG - TIS
15.02.2013 20:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
