Z Series E85 Z4 3.0i (N52) ROADST
51 71 482
Removing and installing/replacing left or right
tension strut (on rear axle)
Special tools required:
•
00 9 120
Important!
Vehicles must not be driven without tension struts.
Driving without tension struts may damage the vehicle body.
Tension strut screws must be tightened to torque and then
tightened down with special tool 00 9 120 .
Release screw (4).
Release screws (1) and nut (3) and remove tension strut (2).
Installation:
Replace screws (1) and nut (3).
-
Insert screws (1).
-
Tighten down screws (1) to specified torque and then to
angle of rotation.
Tightening torque 51 71 5AZ
-
Tighten down nut (3) to specified torque.
Tightening torque 51 71 7AZ
-
Tighten screws (4)
RA Removing and installing/replacing left or right tension strut (on rear axle)
BMW AG - TIS
15.02.2013 20:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
