Z Series E85 Z4 3.0i (N52) ROADST
34 21 745
Removing and installing/replacing left or right
rear brake caliper
Necessary preliminary tasks:
•
Remove rear wheel.
After completing work: Bleed braking system
Press clutch pedal down to floor and secure with pedal support.
Note:
The pedal support may only be released when the brake lines are
reconnected.
This prevents brake fluid from emerging from the expansion tank
and air from entering the system when the brake lines are opened.
Important!
Install brake hose without torsional stress.
First tighten the brake hose on the brake cover, then tighten
connection on brake line.
Never twist brake hose when installing it and avoid all contact
with parts attached rigidly to the body.
Slacken union nut (1); to do so, grip brake hose at square (2).
Installation:
Tightening torque 34 32 1AZ
.
Detach brake hose from brake calliper (3).
Installation:
Tightening torque 34 32 2AZ
.
RA Removing and installing/replacing left or right rear brake caliper
BMW AG - TIS
15.02.2013 21:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
