Z Series E85 Z4 3.0i (N52) ROADST
Open weld joints in areas (1).
Installation:
Adjust wheel arch support to fit.
Also weld areas (2).
Mark severance cut (1) from measurement a to measurement b
and cut complete engine bracket.
Measurement a = approx. 5 mm from edge of front wheel arch.
Measurement b = approx. 50 mm from edge of front engine
carrier.
Installation information:
-
Adjust new part to fit with straightening attachment or
universal mount.
-
Strain beads (2) in contact area of reinforcing panel smoothly
and weld in reinforcing panel.
-
Weld in new wheel arch support part.
RA Replacing front left engine carrier (without wheel arch) (partial replacement be
BMW AG - TIS
15.02.2013 22:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
