Z Series E85 Z4 3.0i (N52) ROADST
Note:
The operation is described on the left side; proceed in the same
way for the right side.
Unfasten screws (1 and 4).
Press wheel arch trim (2) and heat shield (3) to side slightly.
Release nut (5) and disconnect ground cable (6).
All versions:
Release screws (1).
Release expansion rivets (1) on left/right.
Unclip bumper trim (2) in area (1) on left/right outwards.
Pull bumper trim (2) a little in direction of arrow and disconnect
plug connections on license plate lights (3).
If necessary, feed out cable for PDC or TV.
Remove bumper trim (2) with aid of a second person.
RA Removing and installing rear bumper trim
BMW AG - TIS
15.02.2013 22:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
