Z Series E85 Z4 3.0i (N52) ROADST
51 43 010
Removing and installing/replacing rear left or
right upper side trim section
Necessary preliminary tasks:
•
Remove panel for storage box
•
Remove trim behind rollover bar
•
Remove trim for rear speaker
Release screws (1) on side trim (2).
Pull off hardtop locating point cover (1) towards top.
Bend back trim (2) for hardtop locating point and release door
seal (4) in covered area of trim (6).
Unscrew bolt (3).
Release clip (5).
Release screws (2).
Feed out trim (1) under rollover bar trim (3).
Installation:
Make sure end ring is correctly seated on rollover bar trim (3).
RA Removing and installing/replacing rear left or right upper side trim section
BMW AG - TIS
15.02.2013 23:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
