Z Series E85 Z4 3.0i (N52) ROADST
M Roadster / M Coupé only:
Unfasten screws (1 and 4).
Release screws (2) and remove reinforcement plate (6).
Installation:
Replace screws (2).
-
Install all screws
-
Tighten down screws (2) to specified torque
Tightening torque, 51 71 3AZ
.
-
Tighten down screws (1 and 4)
Replacement:
Release screws (3) and remove heat shield (5).
RA Removing and installing/replacing reinforcement plate on front axle support
BMW AG - TIS
16.02.2013 00:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -