Z Series E85 Z4 3.0i (N52) ROADST
Release expansion rivet (1).
Detach adjusting device (2) from lever (3).
Note:
Do not turn adjusting device (2).
Raise actuating handle (1) and release screw (2).
Release screws (3) and (4).
Tightening torque 52 10 7AZ
.
Remove actuating unit (5).
The following work steps are only applicable in the event of
replacement.
Adjusting seat height and backrest inclination:
Unscrew eccentric (1).
Apply acid-free grease to thread (2).
Screw on eccentric (1).
Turn straight areas (3) of eccentric (1) upwards (zero position).
RA Removing and installing/replacing actuating unit on left or right front seat
BMW AG - TIS
16.02.2013 00:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
