Z Series E85 Z4 3.0i (N52) ROADST
54 34 ...
Mounting of hydraulic components
If line connections on the hydraulic unit or the hydraulic lines
remain open for an extended period of time (e.g. storage,
maintenance time), they must be protected against the penetration
of moisture and dirt particles. Proceed as described below in this
respect.
The new method can even be used on older systems.
Screw plugs and cap nuts are included in the "Banjo bolts for
hydraulic unit" kit.
Sealing caps, sealing plugs and screw plugs are included in the
"Hydraulic repair kit" (all sourcing reference: BMW Parts Service).
Connections on hydraulic unit:
Use screw plugs (1) for this purpose.
In case of screw plugs from "Banjo bolts ..." kit, use the old seals.
Connections on cylinder:
Use seal plugs (1) for this purpose.
In case of connections with cap nuts, use seal plugs (as on
hydraulic unit).
Line connections (old):
Use screw plugs (1), cap nuts (2) and old seals for this purpose.
RA Mounting of hydraulic components
BMW AG - TIS
16.02.2013 01:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
