Z Series E85 Z4 3.0i (N52) ROADST
Drill out rivet joint on B-pillar on left/right.
Pull off fabric towards top.
Installation:
Replace shims.
Detach fabric from bow at rear.
Installation:
-
If necessary, remove double-sided adhesive tape.
-
Before installing, fit convertible top fabric on 1st bow so as to
obtain the correct tension.
-
Bring holes of fabric link and bow in line.
Drill out rivet joint (1) from rear tension cable bearing on left/right.
Release screw (2).
Remove fabric.
Feed out tension cables towards front.
Installation:
Replace shims.
Note:
The dimensions and tolerances of the convertible top frame
and the convertible top fabric are designed so that it is not
necessary to correct the tension. After fitting, a new
convertible top fabric is always seated slightly "taut" initially. If
the car remains stationary with the convertible top closed for a
period of time (e.g. overnight), the convertible top fabric
"settles" in such a way that the closing forces return to normal.
RA Replacing convertible top fabric
BMW AG - TIS
16.02.2013 01:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -