Z Series E85 Z4 3.0i (N52) ROADST
54 31 150
Removing and installing/replacing tension
belts
Necessary preliminary tasks:
•
Remove convertible top
•
Partially remove convertible top fabric (without main support
and without last bow)
Feeding out belt at bow 1:
•
Release screws (1) on left/right on inside
•
Retract convertible top a little
•
Pull belt slightly and retract fastening clip
•
Feed out start of belt to center over opening (2) towards top
Unfasten screws on left/right side.
Installation:
Fit belt first at bow 1 to obtain tension. Then insert screw here.
Unfasten screws on left/right side.
Installation:
Guide belt clip from rear over last bow.
RA Removing and installing/replacing tension belts
BMW AG - TIS
16.02.2013 01:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
