Z Series E85 Z4 3.0i (N52) ROADST
Necessary preliminary tasks:
•
Disconnect all necessary cable ties on support tube.
•
If necessary, disconnect plug connections.
Installation:
Make sure wiring harnesses are correctly routed.
Remove screws (1) and (2).
Installation:
Tightening torque 51 71 13AZ
.
Release screws (1).
Pull out current distributor (2) downwards and place to one side.
Installation:
Make sure guide (3) is correctly seated in mounting (4).
Unscrew nuts (5).
Installation:
Tightening torque 51 71 13AZ
.
Unscrew nuts (1).
Installation:
Tightening torque 51 71 13AZ
.
RA Removing and installing or replacing heater
BMW AG - TIS
16.02.2013 03:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
