Z Series E85 Z4 3.0i (N52) ROADST
72 12 004
Removing and installing/replacing airbag
module for driver's knee protection
Special tools required:
•
00 9 317
Warning!
Read and comply with safety regulations for handling airbag
modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
•
Disconnect negative battery cable
•
Remove trim panel for pedal assembly
Release screws (1).
Installation:
Replace screws.
Tightening torque 72 12 19AZ
.
Unlock plug connection (3) and disconnect.
Lever out airbag module for driver's knee protection (4) with
special tool 00 9 317 at holding points (5) and remove.
RA Removing and installing/replacing airbag module for driver's knee protection
BMW AG - TIS
16.02.2013 04:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
