Z Series E85 Z4 3.0Si (N52) ROADST
Block flywheel (1) with special tool 11 9 260 , use an old
transmission screw for this purpose.
Installation:
Replace aluminium screws.
Unfasten flywheel screws.
Tightening torque: 11 22 1AZ
.
Installation:
Flywheel (1) is secured with an alignment pin.
Fit new flywheel screws.
Clean crankshaft thread for flywheel screws.
Secure flywheel with an old transmission screw (1) and special
tools 11 9 260 and 11 9 265 .
Installation:
Replace aluminium screws.
Release flywheel screws with special tool 11 4 180 .
Installation:
Flywheel is secured with a dowel pin.
Fit new flywheel screws.
Tightening torque: 11 22 2AZ
.
Assemble engine.
RA Removing and installing or replacing flywheel (N52)
BMW AG - TIS
16.02.2013 21:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
