Z Series E85 Z4 3.0Si (N52) ROADST
With 1st cylinder in firing TDC position, cams of exhaust
camshaft (3) at 6th cylinder point downwards at an angle.
Note:
If the timing is checked while the engine is installed, the position of
the camshaft can only be checked with a mirror.
Turn sensor gears (2) in direction of arrow until locating pins (1)
on special tool 11 4 290 match up.
Slide on special tool 11 4 290 in direction of arrow.
Secure special tool 11 4 290 with old cylinder head cover
bolts (1).
Screw special tool 11 9 340 into cylinder head.
Pretension timing chain with special tool 00 9 250 to 0.6 Nm .
Tighten both central bolts of camshaft adjustment units with
special tool 00 9 120 . Tightening torque: 11 36 1AZ
.
Assemble engine.
RA Adjusting camshaft timing (N52)
BMW AG - TIS
16.02.2013 22:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
