Z Series E85 Z4 3.0Si (N52) ROADST
Install bearing shell (1) with tip facing down (see arrow) in
cylinder head.
Install bearing shell (2) with tip facing up in bearing cap.
Install eccentric shaft and set to minimum lift.
Bearing cap number 6 (1) is provided with a stop.
All bearing caps (2) are identified with numbers from 1 to 5.
Tightening torque: 11 37 7AZ
.
Assemble engine.
RA Removing and installing/replacing eccentric shaft (N52)
BMW AG - TIS
16.02.2013 22:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
