Z Series E85 Z4 3.0Si (N52) ROADST
Unfasten screws.
Open electronics box cover (1).
Release relay plug on reverse side of cover.
Remove cover.
Installation:
Make sure that cover is correctly inserted in hinges of electronics
box lower section (watertightness).
Disconnect plug (1) and place to one side. Unfasten
grommets (2) on electronics box and lay wiring harnesses to one
side.
Installation:
Make sure that grommets are correctly seated in housing
(watertightness).
Unfasten nut.
Disconnect grounding cable (3) and lay to one side.
Unlock and remove cover (1).
Press tabs to side and remove control unit (1) from mounting.
RA Replacing control unit (DME)
BMW AG - TIS
16.02.2013 22:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
