Z Series E85 Z4 3.0Si (N52) ROADST
Release screws on both knock sensors (1) and remove knock
sensors (1).
Installation:
Replace aluminium screws.
Tightening torque 12 14 1AZ
.
Installation:
Clean support face of knock sensors on engine block.
Note:
Check stored fault messages.
Now clear the fault memory.
RA Removing/replacing knock sensors (N52, N52K, N51)
BMW AG - TIS
16.02.2013 22:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -