Z Series E85 Z4 3.0Si (N52) ROADST
13 62 560
Removing and installing/replacing air-mass
flow sensor (N52)
Necessary preliminary tasks:
•
Switch off ignition
•
Read out fault memory of DME control unit.
Unlock plug (1) and remove.
Unfasten screws.
Pull air-mass flow sensor (2) out of upper section of intake filter
housing.
Installation:
Check sealing ring for damage.
Replace if necessary.
Note:
Check stored fault messages.
Now clear the fault memory.
RA Removing and installing/replacing air-mass flow sensor (N52)
BMW AG - TIS
16.02.2013 23:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
