Z Series E85 Z4 3.0Si (N52) ROADST
23 12 508
Replacing radial shaft seal for drive shaft
(GS6-37BZ/DZ)
Special tools required:
•
23 3 151
•
23 3 152
Important!
After completion of work, check transmission fluid level.
Use only approved transmission oil.
Failure to comply with this requirement will result in serious
damage to the automatic transmission!
Necessary preliminary tasks:
•
Remove transmission.
•
Remove clutch release unit and release lever from guide
tube.
Release screws.
Tightening torque: 23 11 2AZ
.
Remove guide tube (1).
Installation:
Clean guide tube.
Do not grease guide tube.
RA Replacing radial shaft seal for drive shaft (GS6-37BZ/DZ)
BMW AG - TIS
16.02.2013 23:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
