Z Series E85 Z4 3.0Si (N52) ROADST
Necessary preliminary tasks:
•
Remove heat shield on right.
•
Support automatic transmission with hydraulic lifter.
•
Remove transmission cross-member.
Version 1:
Grip clamping sleeve (1) and slacken nut (2).
Detach retainer (3) downwards using a screwdriver.
Pull cable (4) out of holder.
Installation:
Adjust selector lever.
Version 2:
Release screw (1).
Remove clamp (2).
Release shift cable head (3) using a screwdriver from ball head
of shift cable lever.
Installation:
Adjust selector lever.
Version 3:
Unfasten nut.
Remove cable (1).
Installation:
Adjusting cable:
•
Release nut
•
Adjust cable by means of holder (2) until spacing
A = 1 mm is obtained
•
Tighten down nut
RA Replacing mechatronics (GA6HP19Z)
BMW AG - TIS
17.02.2013 00:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
