Z Series E85 Z4 3.0Si (N52) ROADST
Support front axle carrier in area (A) with workshop jack.
Release screws (1, 2).
Lower front axle carrier with assistance of other persons.
Installation:
Check threads for damage; if necessary, repair with Helicoil
thread inserts.
Tighten down first screws (1) and then screws (2).
Tightening torque 31 10 1AZ
.
After installation:
•
Carry out wheel alignment check if a spring strut with support
bearing was or has been installed without centering pin.
•
Carry out steering angle sensor adjustment
RA Removing and installing complete front axle (with spring strut shock absorber)
BMW AG - TIS
17.02.2013 00:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -