Z Series E85 Z4 3.0Si (N52) ROADST
51 47 490
Removing and installing / replacing front
underbody protection
Note:
Illustration shows one example only. There may be differences in
detail in the case of other engine variants.
Release screws (2) and pull out underbody protection (1) from
under bumper trim (3).
Installation:
Ensure that seals are correctly seated.
Center underbody protection (1) and tighten down
screws (2).
RA Removing and installing / replacing front underbody protection
BMW AG - TIS
17.02.2013 00:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -