Removing and Installing Push Rod for Stabilizer Bar in Z Series E85 Z4 30Si
31 35 005
Removing and installing/replacing push rod
(stabilizer link) for stabilizer
Necessary preliminary tasks:
•
Remove front wheel
Release nut; if necessary, grip with engineer's wrench.
Remove hinged bracket (1) from stabilizer (2).
Installation:
Replace self-locking nut.
Tightening torque 31 35 5AZ
.
Release nut; if necessary, grip with engineer's wrench.
Remove stabilizer link.
Installation:
Replace self-locking nut.
Tightening torque 31 35 5AZ
.
RA Removing and installing/replacing push rod (stabilizer link) for stabilizer
BMW AG - TIS
17.02.2013 00:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
