Z Series E85 Z4 3.0Si (N52) ROADST
33 21 035
Replacing gaiter on left output shaft
Special tools required:
•
21 2 120
•
26 1 110
•
33 2 100
Necessary preliminary tasks:
•
Remove output shaft
Clean output shaft.
Press off sealing cap (1).
Installation:
Press on sealing cap with a thrust ring
Coat sealing faces of sealing cap with sealing compound (refer to
BMW Parts Service).
Unfasten hose clip (2).
Press cap (3) off together with gaiter.
Remove circlip (4).
Installation:
Turn new gaiter with cap (3) so that fastener of large hose clamp
is between two bores of constant-velocity joint.
RA Replacing gaiter on left output shaft
BMW AG - TIS
17.02.2013 01:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -