Z Series E85 Z4 3.0Si (N52) ROADST
33 55 000
Removing and installing / replacing rear
stabilizer
Necessary preliminary tasks:
•
Remove both tension struts.
•
Partially lower exhaust system (remove rear muffler from
body)
Release nuts at both ends.
Remove stabilizer link bracket on both sides from control arm.
Installation:
Replace self-locking nut.
Tightening torque 33 55 5AZ
.
Important!
Risk of damage!
To avoid scratching by the stabilizer link bracket, it will be
necessary to tape off the output shafts and lower control
arm.
Release nuts and remove screws towards rear.
Remove stabilizer from rear axle carrier and feed out to right.
Installation:
Check rubber mount on both sides, replace if necessary.
Replace self-locking nuts.
Tightening torque 33 55 3AZ
.
RA Removing and installing / replacing rear stabilizer
BMW AG - TIS
17.02.2013 02:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -