Z Series E85 Z4 3.0Si (N52) ROADST
34 21 320
Removing and installing/replacing both brake
discs
Necessary preliminary tasks:
•
Remove wheels.
•
If necessary, remove and clean brake pads
After completing work:
•
Adjust handbrake.
•
Read and comply with notes on braking in new brake discs /
brake pads.
Important!
The brake discs must be replaced if their thickness is below
the minimum thickness (MIN TH ).
Always replace brake discs in pairs.
If the brake discs are replaced, you must also fit new brake
pads.
Release screws (1). Remove and suspend brake caliper from
vehicle.
Installation:
Tightening torque 34 21 3AZ
.
Note:
Brake hose remains connected.
Unscrew bolts and take off brake disc.
Installation:
Replace brake disc retaining screw.
Tightening torque 34 21 1AZ
.
RA Removing and installing/replacing both brake discs
BMW AG - TIS
17.02.2013 02:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
