Z Series E85 Z4 3.0Si (N52) ROADST
34 31 181
Replacing expansion tank for hydraulic brake
actuation
Note:
Read and comply with General Information
Suck the brake fluid out of the expansion tank. Use a suction
bottle used exclusively for drawing off brake fluid.
Do not reuse drawn out brake fluid.
Unfasten plug connection (1) and disconnect.
If necessary, detach supply hoses (2) of clutch hydraulics and
precharging pump.
Release retaining screw (3).
Installation:
Tightening torque 34 31 3AZ
.
Pull expansion tank vertically out of brake master cylinder.
Note:
Feed hoses must be secured in vertical position so that no fluid
can escape.
Important!
Check rubber plug in brake master cylinder for damage and
replace if necessary.
Push the expansion tank vertically onto the master brake
cylinder.
RA Replacing expansion tank for hydraulic brake actuation
BMW AG - TIS
17.02.2013 02:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
