Z Series E85 Z4 3.0Si (N52) ROADST
Release one wheel stud.
Bring wheel into position (tapped hole turned down approx. 20
°
from horizontal).
F = direction of travel
Installation:
Reinstall wheel stud only after handbrake has been adjusted.
Tightening torque 36 10 1AZ
.
Nipple (1) and expander lock (2) are visible through tapped
hole.
Push in core of handbrake cable in direction of expander lock as
far as it will go and grip firmly.
Press nipple (1) downwards through tapped hole with a
screwdriver.
Installation:
Insert handbrake cable in brake carrier/brake guard plate. Sleeve
must be inserted up to stop.
Nipple of handbrake cable must audibly snap into place in
expander lock.
Unclip handbrake Bowden cables from fixtures (1).
Release screws (2) and lower mounting pan a little.
Installation:
Replace self-locking nuts.
Tightening torque 34 41 4AZ
.
RA Removing and installing/replacing handbrake lever with mounting pan
BMW AG - TIS
17.02.2013 02:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
