Z Series E85 Z4 3.0Si (N52) ROADST
34 51 527
Removing and installing/replacing DSC
hydraulic unit
Necessary preliminary tasks:
•
Read and comply with General Information.
Cars with 6-cylinder engines:
•
Remove front left wheel
•
Remove front left wheel arch trim
All:
After completing work: Bleeding braking system
Press clutch pedal down to floor and secure with pedal support.
Note:
The pedal support may only be released when the brake lines are
reconnected.
This prevents brake fluid from emerging from the expansion tank
and air from entering the system when the brake lines are opened.
Important!
Do not mix up brake lines, mark prior to removal if necessary.
Close off connection bores with plugs.
Disconnect plug connection (1) to control unit.
Unfasten brake lines (2).
Installation:
Tightening torque 34 32 1AZ
.
Unscrew bolt (3).
RA Removing and installing/replacing DSC hydraulic unit
BMW AG - TIS
17.02.2013 02:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
