Z Series E85 Z4 3.0Si (N52) ROADST
36 10 300
Removing or installing front or rear wheel
Special tools required:
•
36 1 250
•
36 1 300
Important!
Wheel was balanced electronically.
Observe the following in order to avoid positioning errors and
imbalance:
-
Loosen wheel bolts.
-
Wheel positioned with valve facing down.
-
If several wheels are removed at the same time, mark the
installation location of the wheels on the tires (e.g. with
chalk).
-
Mark out wheel to wheel hub.
-
Mark out lockable wheel bolt in relation to wheel.
-
Release wheel bolts and remove wheel.
Important!
Contact faces between brake disk and disk wheel and
between brake disk and wheel hub must be free of grease.
Follow instructions on initialising Run Flat Indicator (RPA).
RA Removing or installing front or rear wheel
BMW AG - TIS
17.02.2013 02:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
