Z Series E85 Z4 3.0Si (N52) ROADST
37 14 511
Replacing front ride-height sensor
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Disconnect plug connection.
Release nut (1) and disconnect jointed rod.
Tightening torque 37 14 7AZ
.
Release screws (2) and remove ride-height sensor.
Installation:
Sensor lever must point to rear from ride-height sensor.
Tightening torque 37 14 6AZ
.
After installation:
•
Check headlight adjustment, correct if necessary
RA Replacing front ride-height sensor
BMW AG - TIS
17.02.2013 03:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
