Z Series E85 Z4 3.0Si (N52) ROADST
Loosen screws (1) and (2) on left and right hinges.
Hood lid must be able to be moved.
Note:
If the adjustment range is not sufficient, release retaining
screws of engine hood hinge on body and move hinge.
Locks and retaining hook must snap correctly into place.
Adjust engine hood.
Note:
Vertical adjustment of engine hood to side panel by means of stop
pads.
Note:
Height adjustment of hood lid to front wall:
Release screw (1) and remove cover (2).
Height adjustment by turning at closing hook (3).
Important!
Check function of retaining hook.
Tighten down all slackened screw connections again.
RA Adjusting engine bonnet/hood
BMW AG - TIS
17.02.2013 03:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -