Z Series E85 Z4 3.0Si (N52) ROADST
51 71 374
Removing and installing/replacing
reinforcement plate on front axle support
Special tools required:
•
00 9 120
Important!
Vehicles must not be driven without reinforcement plates.
Driving without the reinforcement plate may damage the front
axle.
Screws of reinforcement plate must be tightened to torque
and then tightened down with special tool 00 9 120 .
All except M Roadster / M Coupé:
Unfasten screws (1 and 4).
Release screws (2) and remove reinforcement plate (6).
Installation:
Replace screws (2).
-
Install all screws
-
Tighten down screws (2) to specified torque
Tightening torque, 51 71 3AZ
.
-
Tighten down screws (1 and 4)
Replacement:
Release screws (3) and remove heat shield (5).
RA Removing and installing/replacing reinforcement plate on front axle support
BMW AG - TIS
17.02.2013 13:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -