Z Series E85 Z4 3.0Si (N52) ROADST
54 34 210
Removing and installing/replacing tension
cable
Necessary preliminary tasks:
•
Remove convertible top fabric at front up to main support
(without last bow) (without convertible top removal)
Drill out rivet joint (1) from rear tension cable bearing on left/right.
Release screw (2).
Remove tension cable from cable.
Feed tension cable out of fabric towards front.
Installation:
Use a pull-in aid (e.g. welding wire).
Replace shims.
RA Removing and installing/replacing tension cable
BMW AG - TIS
17.02.2013 14:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -