Z Series E85 Z4 3.0Si (N52) ROADST
54 34 005
Removing and installing/replacing hydraulic
unit for convertible top drive
Note:
Observe notes on EH convertible top.
Necessary preliminary tasks:
•
Remove convertible top
•
Stow convertible top
Release screw.
Remove hydraulic unit from main bearing.
Installation:
•
Carry out function test
•
Check fluid level, remove/replenish if necessary
Unclip lead clip.
Unclip acoustic cover (1) at catches (2) and remove.
Unclip cable, hydraulic lines and Bowden cable (3).
Unfasten cable clip.
Detach acoustic insulation lower section (4).
RA Removing and installing/replacing hydraulic unit for convertible top drive
BMW AG - TIS
17.02.2013 14:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
