Z Series E85 Z4 3.0Si (N52) ROADST
Release screw (2).
Remove cable holder (1).
Feed cable loom for sensors on convertible top main bearing (3)
out of wiring harness (4).
Removing cable loom for sensor on convertible top catch:
Release screws (1) of front strap on convertible top strip on left.
Feed left front strap (2) out of convertible top strip.
Release the 3 screws of the cable holders behind the convertible
top trim and remove the cable holders.
Pull rubber seal (3) away from frame (2) as illustrated.
Cut through cable band (1) and remove cable loom (4) behind
from holder.
Installation:
Lay cable loom (4) correctly and use a new cable band.
Make sure rubber seal (3) is correctly installed in groove on
frame (2).
Remove trim on convertible top catch.
Release screws (1) and remove cable holder.
Unlock plug connections (3) and disconnect.
Remove adhesive tape (4) and feed cable loom (2) out of
convertible top.
Installation:
Adhesive tape (4) serves to secure the cable loom (2)".
RA Replacing left wiring harness for fully automatic EH convertible top
BMW AG - TIS
17.02.2013 15:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
