Z Series E85 Z4 3.0Si (N52) ROADST
Release screws (1).
Installation:
Tightening torque 51 71 13AZ
.
Release screws (1).
Installation:
Insert screws (1) slightly.
Tighten down screws (1) in sequence (A1-A4) to specified
tightening torque 51 71 14AZ
.
Important!
Remove support tube (2) from vehicle with assistance of a
second person.
Detach support tube (2) and remove from vehicle.
Remove heater (1) in direction of arrow.
Installation:
If necessary, replace seal (2) and seals between heater (1) and
bulkhead.
Make sure condensate drain grommet (3) is correctly seated in
mounting.
Make sure heater (1) is correctly seated in condensate drain
grommet (3).
RA Removing and installing or replacing heater
BMW AG - TIS
17.02.2013 16:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
