Z Series E86 M coupe (S54) COUPE
Insert remaining screws and tighten down.
Note:
Use special tool 11 7 200 to tighten down bolts on VANOS
gear.
Tighten down six accessible screws (three on exhaust side and
three on inlet side) on VANOS gear to 14 Nm .
Remove special tool 11 2 300 or 11 0 480 . Crank engine at
central bolt in direction of engine rotation a further revolution up to
cylinder 1 overlap TDC position .
Note:
TDC allocation above marking on vibration damper is
sufficient.
RA Adjusting camshaft timing (S54)
BMW AG - TIS
06.02.2013 21:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
