Z Series E86 M coupe (S54) COUPE
Note:
In order to ensure correct throttle setting, you must slacken all the
screw connections on the actuating levers with the actuating shaft
except at throttle assembly 1.
It is not necessary to adjust the throttle at throttle assembly 1
because the actuating lever (1) on throttle assembly 1 is
connected via set screw (3) to the actuating shaft (2).
Also do not slacken screw connection of actuating lever of long
pull rod with actuating shaft.
To release screw connection of actuating lever with actuating
shaft, only turn nut (2) and grip screw (1).
Slacken screw connections of actuating levers with actuating shaft
on throttle assemblies 2, 3, 4, 5 and 6.
Adjusting throttle assembly 2:
Move actuating lever (1) of second throttle assembly downwards
until actuating lever (2) rests without play against stop screw (3).
Caution!
Do not exert any pressure!
Tighten down screw connections of actuating levers with actuating
shaft again. Observe the following instructions in so doing:
-
Use screws and nuts only once.
-
Only turn nut (2) and grip screw (1).
-
To screw down, use two open-end wrenches which are to be
placed at right angles to actuating shaft if at all possible. In
this way, no torque is exerted on the actuating lever; such
torque would impair the quality of adjustment.
-
Retighten nut to tightening torque of 7 Nm.
Installation:
If necessary, carry out adjustment with a second person.
RA Adjusting basic throttle setting (S54)
BMW AG - TIS
06.02.2013 22:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
