Z Series E86 M coupe (S54) COUPE
32 13 060
Removing and installing/replacing power
steering gear (S54)
Necessary preliminary tasks:
•
Draw off and dispose off hydraulic fluid from fluid reservoir
•
Remove front wheels
•
Remove front underbody protection
•
Remove reinforcement plate
•
Remove tie rod end on both sides from steering knuckle
•
Remove lower steering spindle from power steering gear
Replacement only:
•
Remove tie rod end at both ends of tie rod
Release banjo bolts (1, 2).
Remove bracket for pressure line from power steering gear.
Disconnect pressure line (4) and return line (3) from power
steering gear.
Installation:
Replace sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 32 41 3AZ
.
Release nuts and remove screws (1) towards bottom.
Remove power steering gear (2) towards front.
Installation:
Replace screws and self-locking nuts.
Tightening torque 32 00 1AZ
.
RA Removing and installing/replacing power steering gear (S54)
BMW AG - TIS
06.02.2013 23:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
