Z Series E86 M coupe (S54) COUPE
32 31 107
Removing and installing/replacing holder for
steering spindle sleeve
Necessary preliminary tasks:
•
Remove complete steering column
•
Remove accelerator pedal module
Fold floor covering in area of holder towards rear.
Release nuts and remove holder.
Installation:
Check seating of sleeve in bulkhead, reattach sleeve if necessary.
Tightening torque 32 31 10AZ
.
After installation:
•
Carry out steering angle sensor adjustment
RA Removing and installing/replacing holder for steering spindle sleeve
BMW AG - TIS
06.02.2013 23:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -