Z Series E86 Z4 3.0Si (N52) COUPE
Release screw (1).
Tightening torque: 11 42 3AZ
.
Remove heat exchanger in direction of arrow.
Installation:
Replace all seals.
Assemble engine.
Installation:
Venting instructions must be observed without fail.
Fill cooling system.
RA Removing and installing/replacing oil-water heat exchanger (N52)
BMW AG - TIS
08.02.2013 07:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -