Z Series E86 Z4 3.0Si (N52) COUPE
Necessary preliminary tasks:
•
Remove coolant thermostat.
Disconnect water hose (1).
Disconnect plug connection (4).
Release screws (5).
Installation:
Replace aluminium screws.
Tightening torque: 11 51 1AZ
.
Installation:
If the water pump is to be reused, it must be mechanically rotated
once (breakaway torque at impellers).
One water pump rotation will be sufficient.
Assemble engine.
Venting instructions must be observed without fail.
RA Removing and installing/replacing water pump (N52)
BMW AG - TIS
08.02.2013 07:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -