Z Series E86 Z4 3.0Si (N52) COUPE
18 40 050
Removing and installing / replacing front
exhaust manifold (N52)
Warning!
Scalding hazard!
Only perform this work after engine has cooled down.
Necessary preliminary tasks:
•
Remove rear exhaust manifold.
Note:
The oxygen sensors are in danger of being damaged when the
exhaust manifolds are removed and installed.
Remove control sensor from cylinders 1 to 3.
Remove monitor sensor from cylinders 1 to 3.
Unscrew nuts.
Remove exhaust manifold (1).
Installation:
Clean sealing faces and replace seals.
Replace nuts.
Tightening torque 18 40 1AZ
.
RA Removing and installing / replacing front exhaust manifold (N52)
BMW AG - TIS
08.02.2013 07:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -