Z Series E86 Z4 3.0Si (N52) COUPE
Disconnect plug connection for lambda monitor sensor.
Release monitor sensor (1) with special tool 11 4 260 .
Tightening torque: 11 78 1AZ
.
Installation:
Cable colour black, cylinders 1 to 3.
Note:
To remove the monitor sensor for cylinders 4 to 6, it is
necessary to remove the exhaust system.
Disconnect plug connection for lambda monitor sensor.
Release monitor sensor (1) with special tool 11 4 260 .
Tightening torque: 11 78 1AZ
.
Installation:
Cable colour gray, cylinders 4 to 6.
Assemble engine.
Check function of DME.
RA Removing and installing/replacing both lambda oxygen monitor sensors (N52)
BMW AG - TIS
08.02.2013 07:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -