Z Series E86 Z4 3.0Si (N52) COUPE
12 51 001
Replacing wiring harness section for engine
(N52)
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
•
Follow instructions for disconnecting and connecting battery
Disconnect battery negative lead from battery and lay to one
side
•
Remove intake air manifold
•
Remove DME control unit
Press locking tab (1) in direction of arrow and pull contact
carrier (2) out of housing.
Press locking tabs (1) in direction of arrow and pull contact
carrier (2) out of housing.
RA Replacing wiring harness section for engine (N52)
BMW AG - TIS
08.02.2013 08:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -