Z Series E86 Z4 3.0Si (N52) COUPE
Secure spring strut against falling out.
Unscrew nuts.
Remove spring strut downwards out of wheel arch.
Installation:
Replace self-locking nuts
Align spring strut using centering pin (1) to bore (2) in wheel
arch or studs to markings on wheel arch.
Tightening torque 31 31 1AZ
.
After installation:
•
Carry out wheel alignment check if a spring strut with support
bearing was or has been installed without centering pin.
RA Removing and installing complete left or right spring strut shock absorber
BMW AG - TIS
08.02.2013 10:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -