Z Series E86 Z4 3.0Si (N52) COUPE
32 34 030
Removing and installing / replacing airbag
unit
Warning!
Observe the following instructions to avoid any risk of injury by
the airbag unit.
-
Comply with safety regulations for handling components
with gas generators.
-
Do not exert any force on the airbag unit.
-
Use only specified tools for releasing the airbag unit.
Note: Incorrect handling may result in triggering of the airbag
unit and thereby cause serious injury.
Important!
Steering wheel must be replaced if airbag unit has been
triggered!
Follow procedure after airbag triggering.
Necessary preliminary tasks:
•
Disconnect battery negative lead
Insert screwdriver (2) at an angle into opening on reverse side of
steering wheel until a spring resistance is felt (approx. 3 cm).
Press spring leg (1) with screwdriver (2) up to stop and pull
airbag unit away from steering wheel.
Repeat procedure on other side.
Installation:
Make sure electrical leads are correctly positioned.
Snap airbag unit with uniform pressing force plane-parallel in
direction of steering column shaft into steering wheel.
RA Removing and installing / replacing airbag unit
BMW AG - TIS
08.02.2013 10:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
